Case Study: My Experience With Wood

A Guide to Wood Science

The Biological research of wood and it’s renewable material is what is referred to as wood science. The processes and the tools used to utilize the material is what is known as wood technology. Wood is treated as a material in direct comparison with other products. The comparison made against other products will include the features of the material against those of wood, the value and the ease it can be worked on. The utilization of technology gives wood an upper hand in most of this comparison. The wide range of products where wood can be used is just one of the many advantages that give wood an upper hand over other products. It is also based on renewable resources. The other merit is that a part of the harvested material is at the same time used as energy to produce the product.

Protection of wooden structure and products is a must if you want to keep the good looks in place. The biggest threat to wood being moisture and insects has to be kept away from the wood. The rotting and decay of the timber products are caused by the moisture and the insects. Many methods are available in the treatment of wood one of the most common being the ACQ – alkaline copper Quaternary. The protection of from this chemical is based on copper. Although being a good method to use for wood protection it has presents some few challenges. The chemical is highly corrosive to most metals, the chemical corrodes away galvanized fasteners and therefore only stainless steel is used. The species of the wood and the application of the wood will determine how many chemicals will be used on the wood. The concentration level of the chemical will be different for two pieces of wood where one is used above ground and the other close to a water body.

Another wood treating method that is fast being accepted is the use of copper metal. This method, unlike the ACQ, is friendly to the metal fasteners and its gaining popularity very fast. Micronized copper wood preservative is the correct term to refer this type of preservation. The copper metal is applied to the wood as small microscopic particles injected into the wood at high pressure. The process eliminates the need to dissolve the copper as is done in earlier copper-based preservatives. This process is highly effective and the wood properties and heightened. The timber treated in this way is used in both outdoor and indoor frames that last very long.

Termites and fungal decay are just a few among the many problems wood treated from this method are protected against. Unlike other methods of treatment this method is not corrosive. The wood treated using this method last longer and is stronger.